Universal clamp meter with automatic range selection for every measurement allows for basic and advanced measurements of electrical quantities. The meter is equipped with measurement clamps that allow measurement of both direct and alternating current in a single wire using a built-in HALL sensor. The measurement can be done without disconnecting the circuit or disconnecting it from the power source and allows for measuring much higher current than conventional electrical meters.
measurement of alternating voltage: A.C. 0-600 V, TRUE RMS
measurement of direct voltage: D.C. 0-600 V
measurement of alternating current: A.C. 0-600 A, TRUE RMS
measurement of direct current: D.C. 0-600 A
measurement of resistance: 0-60 MΩ
diode test: IF 5 mA, UR 3 V
continuity test: 0-50 Ω
Power supply: two 1.5 V batteries (AAA)