IN (1/4” jack X 2)
For input of the signals from the sources. The sources may be the outputs of any type of
musical instrument or amplifier speaker output. (WARNING! When connecting to speaker outputs, the Direct2 does not supply the proper amplifier load required by most tube type amplifiers. Do not use a tube amplifier’s speaker output alone with the Direct2. You must also have a speaker or appropriate dummy load connected to avoid possible damage to the amplifier.
OUT (1/4” jack X 2)
A “Y” connection or “loop through” from the input.
OUTPUT 1, OUTPUT 2 (XLR jacks)
Male XLRs, which provide balanced low impedance (150 Ohms) signals suitable for
connection to balanced, low-Z equipment (mixing console, workstation, etc.)
PAD (Switch X 2)
Most instruments will operate properly when set to the OUT position. Set to the IN position
(applies an